Correct and prep all in one step!
BLACKFIRE Pro Primer Polish was designed to perfectly prep your paint for BLACKFIRE Pro Ceramic Coating by removing allowing you to simultaneously correct and strip your paint. The lifetime and hardness of your ceramic coating will be drastically improved due to the Silica that is contained in the formula for BLACKFIRE Pro Primer Polish. BLACKFIRE Pro Primer Polish saves you quite a lot of time when applying a ceramic coating by both correcting minor swirls and scratches and prepping the paint to full bond with your ceramic coating. Even if you do not plan on applying a coating, BLACKFIRE Pro Primer Polish can be used as a stand-alone correction and protection product.
Ceramic coatings are one of the most innovative advancements in the automotive detailing industry. They have supplied an easily accessible alternative to traditional waxes and sealants that is capable of providing a much higher level of protection to your paint. Not only that, but the lifetime of ceramic coatings is typically measured in years, not months like traditional waxes. The downside to these incredible protective products is that they are quite particular about the condition of the surface to which they are applied. If there is any oils, waxes, or sealants remaining on your paint surface, ceramic coatings will not properly bond. You must use a product prior to your ceramic coating that will rid the surface of these troublesome factors and allow your coating to bond properly. BLACKFIRE Pro Primer Polish is a non-abrasive, solvent-free polish that will effectively remove any substances that would prevent you from getting the most out of your ceramic coating.
Once you have applied a ceramic coating to your paint surface, it will act as a magnifying glass and amplify the effects of any scratches or swirls that are embedded in your clear-coat. Therefore, it is crucial that you remedy these imperfections prior to applying your ceramic coating. BLACKFIRE Pro Primer Polish will correct the minor swirling and scratches that may exist in your paint, leaving behind a flawless surface before you apply your coating.
The Silica technology contained in the formula for BLACKFIRE Pro Primer Polish is the same Silica that is used in the majority of ceramic coatings on the market. By applying a thin layer of this Silica on your paint surface, BLACKFIRE Pro Primer Polish gives your ceramic coating anchor points that it will be able to latch onto, creating a much stronger bond to your paint.
Even if you are not planning on applying a ceramic coating to your paint, BLACKFIRE Pro Primer Polish is still a great product for you. Because BLACKFIRE Pro Primer Polish contains Silica, it will leave behind its own layer of protection as well. This allows you to use BLACKFIRE Pro Primer Polish as a stand-alone correction and protection product that will protect your paint up to 6 months.
For best results, BLACKFIRE Pro Primer Polish should be applied with a machine polisher. Ensure the surface is cleaned and dried prior to application. Shake well. Apply serval quarter-sized drops of product onto a foam polishing or all-in-one pad and spread over the surface while the machine is still off. Turn polisher on low and gradually increase speed and pressure. Work until polish is no longer noticeable and remove the excess product using a clean microfiber buffing towel. Continue around the vehicle. Allow cure time of 1 hour before applying paint coating.
5 Gallon (640 oz.)
This product is not available for expedited shipping.